Technoline WS 9117 Datasheet Page 1

433 MHZ TEMPERATURE STATION Instruction Manual INTRODUCTION: Congratulations on purchasing this innovative 433MHz Temperature Station which displays

be received and stored by the Temperature Station in the first 2-1/2 minutes of power being supplied to it. LCD SCREEN The Temperature Station’s LCD

52 Outdoor TemperatuºC oTransmitter identre inr °Fification numberTime Indoor Temperatin ºC ourer °FOutdoor Transmission signal

12 or 24 hour setting: After the batteries are inserted, set the time display as follow: 1. Press and hold the “SET/CH” key about 3 seconds to enter

CELSIUS OR FAHRENHEIT DEGREE SETTING: Following from the 12 or 24 hour setting mode. 1. Either a “°C” or “°F” will appear on the LCD. If “°C” is disp

1. The Hour digit in the time section starts flashing 2. Using the “MIN/MAX” key, enter the hours of the current time and then followed by pressing t

USING THE TEMPERATURE STATION: INDOOR TEMPERATURE: The indoor temperature is displayed on the second line of the LCD under the time. The Temperature

MINIMUM AND MAXIMUM INDOOR TEMPERATURE RECORDINGS: Maximum icon Minimum icon Indoor sign 57

By pressing the “MIN/MAX” key the current indoor temperature will alternate between the minimum, maximum and current temperature recordings (also chan

Note: Should the outdoor temperature not be received within 2-1/2 minutes after inserting the batteries into a transmitter, then see “Checking 433 MH

MINIMUM AND MAXIMUM OUTDOOR TEMPERATURE READING: Minimum icon Maximum icon Outdoor sign 60

TEMPERATURE STATION: SET/CH keyMIN/MAX keyHanging hole Detachable stand Battery compartment 43

By pressing the “MIN/MAX” key the current indoor and outdoor temperature will alternate between the minimum, maximum and current temperature recording

RESETTING THE MINIMUM AND MAXIMUM TEMPERATURE RECORDING: By pressing and holding down the “MIN/MAX” key for about 3 seconds, both the indoor and outdo

temperature readings of transmitter 1, 2, and 3, simply press the “SET/CH” key. If the reading is from transmitter 1, then the identification numbers

1. The distance of the units should be at least 1.5 - 2.0 meters away from interfering sources such as computer monitors or TV sets. 2. Avoid placi

reception is only possible once all other electrical products using the 433 MHz are switched off. 5. Within thick concrete rooms such as basements an

Note: Should after checking the above list and the outdoor temperature is still not received, then reset the units (see Resetting the Temperature Sta

POSITIONING TEMPERATURE STATION: The Temperature Station comes complete with a detachable stand that gives the option of table standing or wall mounti

OUTDOOR TRANSMITTER: The Outdoor Transmitter is supplied with a holder that may be attached to a wall with the three screws or double-sided tape suppl

The Outdoor Transmitter simply clicks in or out of the holder. When inserting or removing the Outdoor Transmitter to or from the wall holder please ho

securing in place, please ensure that the Temperature Station can receive the 433 MHz signal from the Outdoor Transmitter at the positions that you wi

TEMPERATURE TRANSMITTER: Holder 44

• When cleaning the LCD and casing, use a soft damp cloth only. Do not use solvents or scouring agents. • Do not submerge the units into water. •

SPECIFICATIONS: Temperature measuring range Indoor : 0ºC to +60ºC with 0.1ºC resolution 32ºF to +140ºF with 0.2ºF resolution (--.- displayed if out

Temperature checking intervals Indoor temperature : every 10 seconds Temperature Station Outdoor Temperature reception : twice in 10 minutes Trans

Battery life for both units : Approximately 12 months (Alkaline batteries recommended) Dimensions (L x W x H): Temperature Station : 58 x 23

LIABILITY DISCLAIMER • The electrical and electronic wastes contain hazardous substances. Disposal of electronic waste in wild country and/or in unau

• As stated on the gift box and labeled on the product, reading the “User manual” is highly recommended for the benefit of the user. This product mus

• The specifications of this product may change without prior notice. • This product is not a toy. Keep out of the reach of children. • No part of

R&TTE Directive 1999/5/EC Summary of the Declaration of Conformity : We hereby declare that this wireless transmission device does comply with th

FEATURES: • LCD clock in 12 or 24 hour time display • Indoor and outdoor temperature reading in degrees Celsius or Fahrenheit • Can receive up to t

BATTERIES REPLACEMENT & MAINTENANCE: For best performance, batteries to all units should be replaced at least once a year to maintain optimum runn

SETTING UP: Please follow these steps to ensure that your new Temperature Station works correctly with the temperature transmitter(s): Batterycom

1. Flip open the battery cover at the back of the Temperature Station as indicated above. 2. Checking the correct polarization, insert 2 x AAA, IEC

transmitter before activating the next transmitter by repeating steps 3 and 4. 6. However, ensure that you leave 10 seconds in between the reception

Note: Should the total time of inserting the batteries into the transmitters take longer than 2-1/2 minutes from the time of inserting the batteries i