Technoline WT 590 Datasheet download pdf (Page 4)

1. Connect the power adapter to a wall socket

2. Insert the adapter into the jack at the bottom of the clock

3. The Projection clock will now start receiving the DCF time signal. After approximate 3 to 5 minutes, the

DCF time will be displayed.

4. If reception is not successful within approximately 7-10 minutes, the Projection clock will attempt to

receive the signal in the following hour.

Your Projection clock is now operational.

Note:

If the Projection clock is powered through the adapter, the projection will be constantly ON at the highest

brightness level unless the brightness level is manually changed to a lower brightness level afterwards. And

the

brightness of the projection can be change accordingly to enhance the clarity of the projected time by

pressing the

key.

If the Projection clock is battery operated, the projection will be ON at the highest brightness level only when

the SNOOZE key is pressed. The intensity of the brightness level of the projection cannot be changed. If the

SNOOZE is released, the projection will be turned OFF.

Important!

If the DCF-77 signal is not being received, no keys functions can be used. In that case, either

wait for the next reception of the DCF signal or proceed to manual time setting after reset of

the clock for activation of the keys function.

1 2 3 4 5 6 7 8 9 ... 13 14

No comments

Technoline WT 590 Datasheet Page 4